Device Actions

Actions for new devices

Introduction
This module allows you to set up the actions you want to associate when you plug new devices.
Screenshot of the Device Actions Manager
Screenshot of the Device Actions Manager
You will see listed all of the possible actions that are available when devices are plugged in. Please note that they will only be available under certain conditions.
Add This will ask you to supply a name for your new action, then will open that action for editing. If you do not supply all the required details in that dialog, then your action will be deleted.
Edit This will allow you to change the Name, Icon, command to execute and the conditions the action must match to be shown.
Discard / Cannot be deleted / Remove This will do different actions, depending on if it was supplied with your system or created by you. You can only discard changes to system wide actions, if there are no changes then these actions cannot be deleted. User created actions are completely removed, including all changes.

Add Action
The Add button brings you a dialog to enter the new action name.
Screenshot of the Add Action dialog
Screenshot of the Add Action dialog
The action name should correctly describe the action. After entering a name and clicking OK, the Edit Action dialog will show to allow you to set up the action properties.

Edit Action
This dialog allows you to change the settings of the action you selected.
Screenshot of the Edit Action dialog
Screenshot of the Edit Action dialog
This includes the icon, the action name, the action command and the various parameters. You can change the icon by clicking on it.
The parameters are displayed in a tree, the top item having to be true in order for the action to be shown.

Edit parameter
Parameter type 	 This controls what can be contained inside it, or what matching is performed to check if it is true.
Property Match 	 Compares the specified property of the Device (using Device type and Value name) and using the evaluator, compares it against the text provided.
Content Conjunction 	 All sub-properties of this must be true for it to be true itself.
Content Disjunction 	 Any sub-property of this may be true for it to be true itself.
Device interface match 	 Checks to see if the Device can be classed as the selected Device type.
Device type 	 These are the possible device types supported by on your system. They are used in both Property and Device interface matches.
Value name 	 This is a list of all possible property names for the selected device type. It also provides the selection of the value evaluator (which is either Equals or Contains), and allows entry of the text to be compared with.
Reset Parameter 	 Reverts any unsaved changes you have made to this parameter.
Save Parameter changes 	 Saves the changes you have made to the parameter.